If the fan does not work, or there are other problems, try reading our troubleshooting guide for more information. When the remote comes from the factory, the dip switches will all be set to up. You can use any unique pattern you like but the more unique the setting or pattern, the less likely it is your fan will end up being controlled accidentally by someone with the same remote or similar remote or even just a remote set to the same dip switch settings.
Somewhere around Some site visitors look for how to change the frequency to Mhz instead, because at this frequency you may be able to control the fan through other means. Can I program two remotes to work with one fan? Or, can one fan have two receivers so I can have two remotes? If you pop off the remote battery cover you will see them toward the top of the battery compartment. Dip Switch Programming Programming a ceiling fan is not the same or even close to programming a remote control for the TV, or other appliances.
Setting the code on the remote a First thing is to remove the battery cover b Set the dip switches. What frequency does a Harbor Breeze Ceiling Fan operate on? Table of Contents. Make sure you hold the reset button down until the light comes on and the ceiling fan speed goes to medium.
This step should be done within three minutes of restoring power to the fan. Your fan should turn on low speed indicating the pairing was successful. How do you program harbor Breeze remote? To program the Harbor Breeze ceiling fan remote you should first shut the electricity off. Then, access the circuit breaker switches of the remote by opening the cover of the service panel.
Now, the look at the back of the Harbor Breeze ceiling fan remote and take the battery compartment cover out.
0コメント